Wireless Home Alarm System

Wireless Burglar Alarm Systems Malaysia | Alarm Systems

Installation

Step 1:

Placing the sensor and magnet at top end corner of door / window

Step 2:

Clean the surface of door beam and door panel with dry cloth.

Step 3:

Peel off the double sided foam tape cover from sensor.

Step 4:

Stick sensor at the top end corner of door panel.

Step 5:

Now, peel off the double sided foam tape cover from magnet.

Step 6:

Then stick the magnet to door beam.

Step 7:

Not to forget, positioning the magnet near sticker label
“MAGNET POSITION” of sensor.

Step 8:

Sensor & magnet must not touch each other. ( To test, if you open the door, red LED on the sensor will illuminate. )

Step 9:

Sensor & magnet will disengage if intruder open your door. If you arm the Main unit, the moment it receive signal from sensor, automatically activating the siren.

Change 9Vdc Alkaline battery :

Step 1:

Slide open the door cover of sensor

Step 2:

You can see a 9Vdc Alkaline battery inside

Step 3:

Just pull out the cable and change it.( Change the battery once a year. )

Web Design by Acdra Sdn Bhd